Ip 224 Technical Datasheet 5z1a3k

IP-224 Ethernet Adapter The IP-224 Ethernet Adapter provides a means of controlling two (2) audio devices remotely. The IP-224 can be configured to operate in modes that allow it to connect to both digital and analog consoles, and perform a variety of other tasks related to using radios on a digital network. Installation and service is easy. The IP-224 can be rackmounted or placed directly on the desktop. A sleek LCD display provides when programming. VU meters are provided on the front display for alignment purposes. All other configurations are completed in the web browser configuration windows. PCB is hot swappable.

Features Ethernet TX and LINK LEDs

Backwards Compatible with Telex Radio Dispatch Products

PTT (Push To Talk) Monitor, F1 and F2 relays

Secure Remote Web Browser Programming and Configuration

Four (4) PTT Modes and Three (3) Monitor Modes

Single or Dual Function Tone Generation

Nine (9) Selectable PTT Frequencies

Guard Tone -Selectable for 2100Hz, 2175Hz, 2300Hz, 2325Hz, 2400Hz, 2600Hz, 2800Hz, 2850Hz or 2900 Hz

Seven (7) Digital Outputs for Channel Selection CTCSS (Continous Tone Coded Squelch System) Generation (64 frequencies)

Menu Driven Front Control for TX, RX, Spare Audio, and CTCSS Kenwood1 Radios :

Software Gain Control

x80 Series

x90 Series

Direct Radio Control

x180 Series

5 x 10 P25 Series

Handset Port for Monitoring Activity and Transmission

x150 Series

NEXEDGE

Single Function Tone Recognition (16 Function Tones)

EF Johnson1 RS5300 P25 Radio Interface

AGC (Automatic Gain Control)

Nextel iDEN1

RX (Receive) Audio Squelch

Motorola2

ANI (Automatic Number Identification) Over-the-Air Protocol

Phone System

Up to 1000 function tones ed

iCOM1 Radios

MDC1 and FleetSync1 Encode/Decode

Vertex1 Radios

SOIP (Serial Over Internet Protocol)

Sepura1 Radios─SRM2000 TETRA

Dual Ethernet Interface for Backup Solution s RS485, CAN Bus, RS232 and TTL 2 See copyright notice ** on back.

1 See copyright notice * on back.

Line Drawing FCC Compliance: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.



IP-224 MENU

ETHERNET

RADIO 1

ACCESSORY



+12V GND EGND IC RADIO 1

RADIO 2

HANDSET

USB

TX

LINK

RADIO 2 POWER

PRIM

SECOND

w w w. t e l e x r a d i od i s p a tc h .c o m

Specifications Power Requirements ....................................................................................................... +11VDC to +16VDC, 600mA max. Ethernet Speed ..................................................................................................................... 10 BaseT or 100 BaseTX Flash Memory .................................................................................................................................................. 128MB SDRAM Memory .................................................................................................................................................. 128MB Lease Line ............................................................................................................... 2-Wire and 4-Wire ed Radio Interface ......................................................................................................................±45VDC withstand rating Hum and Noise ..................................................................................................60dB below rated output for each line Non-Relay Outputs ........................................... Open collector, active low, 200mA max., 40V collector to emitter voltage Radio Input Level ............................................................................................................10mVp-p to 10Vp-p, adjustable Line Output Level ............. 10mVp-p to 10Vp-p, adjustable (Single Ended), 20mVp-p to 40Vp-p, adjustable (Balanced) Tone Frequencies ................................................................................................Single or dual function tone generation Function tone range 0 Hz–3200Hz adjustable in 1Hz increments, Total tone duration 0 ms–999ms, Tone magnitude -60dB to +12dB Vocoder ................................................................ ADPCM 32/16Kbits (34 bits or 50Kbits network bandwidth utilization for simplex operation respectively) Relay Ratings ..................................................................................................................................1A at 63V AC/DC Digital I/O Ratings ............................................................... Pull up/pull down/float 3.3VDC/5VDC/12V 10K Ohm pull up Transmit Output Impedance .......................................................600 Ohms for balanced mode, 200 Ohms for single-ended mode Receive Input Impedance .....................................................................................................10/600/10K Ohms (-selectable) Audio Distortion ....................................................................................................................................... 2% THD max. Audio Frequency Response .............................................................................300Hz to 3000Hz + 1, -3dB less than 3% distortion LAM Sensitivity .................................................................................................................................... -50dB to +10dB COR Sensitivity .................................................................................. -selectable rising or falling edge from radio DTMF Detection Bandwidth ....................................................................................................... ±25Hz around center of frequency Monitor Timer ................................................................................................................ 10ms to 9999ms, adjustable Control Type ............................................................................................................. 32-bit Digital Media Processor Electro Static Discharge Immunity ..................................... 8kV on all exposed operator control areas. At 8kV no operation is disturbed. At 8kV no permanent damage. Line Protection ................................................................................................Fast-action solid state surge protection Memory Protection .......................................................................................... Settings preserved in non-volatile memory Level Controls .............................................. Menu driven front controls for TX, RX, spare audio, and CTCSS Operating Temperature Range ............................................................................... 0°C to 50°C (32°F to 122°F) for full specifications Storage Temperature Range ............................................................................ -30°C to 65°C (65°F to 149°F) for full specifications Dimensions ................................................ 1.625” H x 11.5” D x 8.5” W (41.3mm H x 292.1mm D x 215.9mm W) Actual Weight ....................................................................................................................................4.125lbs (1.9kg) Shipping Weight and Dimensions ....................................... 7lbs (3.18kg ), 5” H x 16” W x 15” D (127mm H x 406.4mm W x 381mm D)

Product Information

Part Numbers IP224 Beacon • IP224-Standard Beacon Series (no options) IP224 wOps @PI • IP224-with options@PI

Options

Optional Cables DB37 KenTKX150 • IP224-KNWS TK-X150/TKX180 Interface Cable DB37 KenTKX 90 • IP224-KENWOOD TK-X90 Interface Cable DB37 SRM2000 • IP224-SEPURA Interface Cable DB37 650370 • IP224-650370 IP223 TO VIPER CABLE ADAPTOR DB37 Cabtone • IP224-CABTONE CABLE ASSEMBLY DB37 CDM1250 • IP224-MOTO CDM1250 Cable INTERFACE TDI for IP224 • IP224-TDI Interface (includes cables) MTRBI for IP224 • IP224-MTRBi Radio Interface (includes cables) EFJ5300_Cable • IP224-EFJ 5300 Radio Interface (CABLE ONLY) iDen_Cable • IP224-iDEN Radio Interface (CABLE ONLY) Optional Hardware IP224 MB Dual • IP224-Mounting Brackets (dual) IP224 MB Single • IP224-Mounting Brackets (single)

Optional Software Fltsy D 224@PI • IP224-FltSync Decode SW @PI Factory Fltsy DE 224@PI • IP224-FltSync Dec & Enc SW @PI Factory MDC DC 224@PI • IP224-MDC1200 Decode SW @PI Factory MDC D&E 224@PI • IP224-MDC1200 Dec & Enc SW @PI Factory NI223+ IP224@PI • IP224-iDEN SW & Cable @PI Factory FltsyD224@PI FL • IP224-FltSync Decode SW @PI Field FltsyDE224@PI FL • IP224-FltSync Dec & Enc SW @PI Field MDC DC224@PI FL • IP224-MDC1200 Decode SW @PI Field MDCD&E224@PI FL • IP224-MDC1200 Dec & Enc SW @PI Field IP25300@PI FL • IP224-EFJ5300 SW & Cable @PI Field NI223+@PI FL • IP224-iDen SW & Cable @PI Field

Bosch Security Systems, Inc. | 8601 East Cornhusker Highway | Lincoln, Nebraska 68507 Telephone: (800) 752-7560 | Fax: (402) 467-3279 Form Number: F01U216769 Rev 02 Date: October 2011

The specification information is preliminary and is subject to change without notification. *Brand names mentioned are the property of their respective companies. **MOTOROLA and the Stylixed M logo are registed in the U. S. Patent ad trademark Office.

w w w. t e l e x r a dio d is p a tc h . c o m