Detail Waterproofing 4i1h1k

Flat Roof with Vent Pipe Pipe abraided and primed with Conc.2525 Primer Sonol.Ultra Polyurethane t sealant

Conipur Tc 458

Fall

RC Roof Slab Conc.2525

Existing Cement::Sand screed laid to fall

1

Gutter/Parapet wall detail on Flat Roof 3mmx3mm reglet for membrane termination filled with S.Ultra sealant

Conipur terminate 300mm high upturn tucked into reglet

Conideck system

Existing Cement:Sand screed to fall

Mortar fillet made from Conc.2525+filler

Conipur M865Z detailing to downpipe

2

Discharge Pipe Detail at Podium/Balcony/Terrace Floor trap cover

FALL

FALL

Tile finishes by others Levelling screed by others Air-con discharge pipe 20mm thick cement.sand protective screed

Sonoshield HLM 6000 1:3 cement/sand screed laid to fall

150

R.C. Slab Construction grout-shrinkage compensated grout to fill recess Discharge Pipe 3

Swimming Pool Detail WATER LEVEL

POOL DECK LEVEL

Non slip ceramic tiles and adhesives by others Finemesh reinforcement fixed spindle at 450mm contres glued to concrete with Concresive 1438 Sonoshield HLM 6000 Non-slip ceramic tiles and adhesives by others

1:3 cement/sand protective screed

Sonoshield HLM 6000 on 1:3 cement/sand screed laid to fall

Sonoshield HLM 6000 Finemesh extended to 500mm on horizontal surface

Masterflex 610

Angle fillet constructed from non-shrink mortar

CAR PARK BELOW

500

4

Gutter Detail at Roof Protective screed reinforced with finemesh

FALL

10mm x 10mm reglet for membrane termination filled with Sonolastic NP1 sealant

50mm thick in-situ 1:3 cement/sand screed reinforced with finemesh, s of 750mm x 750mm with 10mm wide t filled with Sonolastic PS2 Polysulphide sealant

Drainage cell

Masterpren 2003 Separation layer

Mortar Fillet 50mm thick extruded insulation board

R.C. Roof Slab

Masterpren 2003

Sonoshield HLM 6000 Detailing around pipe Downpipe

25mm minimum thick castin-situ 1:3 cement/sand screed laid to fall 5

DETAIL FOR PIPE PENETRATION CREATED THROUGH EXISTING FLOOR Masterflex 610 + 611 swellable paste wrapped in helical profile HLM6000 Barralastic Masterflow 98

Bathroom Floor Slab

6

Plan View of Penthouse Unit at Pantip Shores

Penthouse Unit

Bathroom area

Bathroom area

7

Bathroom Area with brick infill wall

For shower area, upturn of 1.8m. For non-shower area 0.15m to prevent back splashing of water

For brick wall the brick surface must be plastered to receive Barralastic

Wall tiles by others Floor tiles by others Tile bedding by others

Barralastic (2 applications) on 3:1 sand:cement screed laid to fall (optional ) Slab

10mm x 10mm mortar fillet

8

Bathroom Area with Stud & Frame Drywall infill fixed to Stud & Frame To be primed with Acryl 60 to receive Barralastic

For brick wall the brick surface must be plastered to receive Barralastic

Wall tiles Floor tiles Tile bedding

Barralastic (2 applications) Reinforced with Sonoshield Reinforcement at upturn Slab

10mm x 10mm mortar fillet

9

Down Pipe Detail Barralastic 2 coats

Floor trap cover Fall

Tiles Finishes installed Using Nano-Light Air-con water discharge pipe

Barralastic 50mm into downpipe

Masterflow 98 non shrink grout to fill box-out opening

Discharge pipe 10

Wet Area Vent Pipe Detail Mortar Fillet

Fall

NP-1 t sealant

Floor tiles Tile bedding 2 mm of protection layer

100mm

Barralastic Barralastic (2 coats)

Masterflow 98 to fill box-out opening in the floor

3:1 sand:cement screed laid to fall (optional)

R.C Floor slab

pipe abraded to provide a mechanical key 11