Asus Zenfone 2 Teardown 1k5xo
This document was ed by and they confirmed that they have the permission to share it. If you are author or own the copyright of this book, please report to us by using this report form. Report r6l17
Overview 4q3b3c
& View Asus Zenfone 2 Teardown as PDF for free.
More details 26j3b
- Words: 567
- Pages: 6
Asus Zenfone 2 Teardown
Asus Zenfone 2 Teardown This is a teardown for the ASUS ZenFone 2. You can use it for reference while taking your device apart and for checking out what's inside.
Written By: Arijit Guha
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 6
Asus Zenfone 2 Teardown
INTRODUCTION I am Arijit Guha, a computer science engineer by profession and I have taken apart every gadget I have ever come across in my life. I own this device and this one is no exception.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 6
Asus Zenfone 2 Teardown
Step 1 — Removing the rear cover
Unscrew all the 14 screws. There are two strips of adhesive running top to bottom beside the sim card slots so be patient and slowly remove the rear cover.
Step 2 — Removing the battery
The battery connector is the connector at the right of the motherboard. Above the battery, there is a bridge connector which connects the mainboard with the sub board at the bottom. So remove both the cables. There is a slight adhesive below the battery. Cut through it with a plastic spudger and it will come out.
The sub board has the antenna terminals also and prior to removing the battery, the antenna cable needs to be removed as well. Gently disconnect the coaxial cable from both the motherboard and the sub board.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 6
Asus Zenfone 2 Teardown
Step 3 — Removing the motherboard
Remove the copper tape adhered to the mid-frame. The motherboard is held to the mid-frame using 4 plastic clips. I found that starting to pry up the motherboard from the right is easier than from the left. Just apply mechanical sense and you will get the motherboard out in no time.
Make sure not to bend the motherboard from too much pressure.
Step 4 — Battery information
The battery is rated at 3.85V, 11.5 Wh. The capacity is 2900 mAh minimum and 3000 mAh typical.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 6
Asus Zenfone 2 Teardown
Step 5 — Motherboard details - Bottom side
© iFixit — CC BY-NC-SA
www.iFixit.com
Removing the shields from the motherboard will expose the components.
Bottom side components:
SK Hynix H26M52103FMR 16 GB eMMC 5.0 flash memory
Intel 8818 XGold 223
Intel PMB 5747 RF Controller
SkyWorks 77627-11 Network Power Amplifer Module
Murata 6PH47
Qualcomm SMB 1357 Quick Charge 2.0 IC
Page 5 of 6
Asus Zenfone 2 Teardown
Step 6 — Motherboard details - Front side
Intel PMB 6830 - Power Management IC
Winbond W978H6KBVX2E - 256Mb Low Power DDR2 SDRAM used for aiding the baseband processor.
Intel PMB 9933 Baseband processor
SK Hynix H9CKNNNTMR - 4 GB LPDDR3 RAM with the Intel Atom Z3560 processor layered underneath as PoP.
Realtek ALC 5647 audio chip.
Broadcom BCM4339XKUBG - Dual band WiFi controller.
The proximity sensor, notification LEDs and the 3.5 mm audio jack are all soldered to the motherboard.
The front and rear cameras can be easily removed from the motherboard
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-20 03:29:02 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 6 of 6
Asus Zenfone 2 Teardown This is a teardown for the ASUS ZenFone 2. You can use it for reference while taking your device apart and for checking out what's inside.
Written By: Arijit Guha
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 6
Asus Zenfone 2 Teardown
INTRODUCTION I am Arijit Guha, a computer science engineer by profession and I have taken apart every gadget I have ever come across in my life. I own this device and this one is no exception.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 6
Asus Zenfone 2 Teardown
Step 1 — Removing the rear cover
Unscrew all the 14 screws. There are two strips of adhesive running top to bottom beside the sim card slots so be patient and slowly remove the rear cover.
Step 2 — Removing the battery
The battery connector is the connector at the right of the motherboard. Above the battery, there is a bridge connector which connects the mainboard with the sub board at the bottom. So remove both the cables. There is a slight adhesive below the battery. Cut through it with a plastic spudger and it will come out.
The sub board has the antenna terminals also and prior to removing the battery, the antenna cable needs to be removed as well. Gently disconnect the coaxial cable from both the motherboard and the sub board.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 6
Asus Zenfone 2 Teardown
Step 3 — Removing the motherboard
Remove the copper tape adhered to the mid-frame. The motherboard is held to the mid-frame using 4 plastic clips. I found that starting to pry up the motherboard from the right is easier than from the left. Just apply mechanical sense and you will get the motherboard out in no time.
Make sure not to bend the motherboard from too much pressure.
Step 4 — Battery information
The battery is rated at 3.85V, 11.5 Wh. The capacity is 2900 mAh minimum and 3000 mAh typical.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 6
Asus Zenfone 2 Teardown
Step 5 — Motherboard details - Bottom side
© iFixit — CC BY-NC-SA
www.iFixit.com
Removing the shields from the motherboard will expose the components.
Bottom side components:
SK Hynix H26M52103FMR 16 GB eMMC 5.0 flash memory
Intel 8818 XGold 223
Intel PMB 5747 RF Controller
SkyWorks 77627-11 Network Power Amplifer Module
Murata 6PH47
Qualcomm SMB 1357 Quick Charge 2.0 IC
Page 5 of 6
Asus Zenfone 2 Teardown
Step 6 — Motherboard details - Front side
Intel PMB 6830 - Power Management IC
Winbond W978H6KBVX2E - 256Mb Low Power DDR2 SDRAM used for aiding the baseband processor.
Intel PMB 9933 Baseband processor
SK Hynix H9CKNNNTMR - 4 GB LPDDR3 RAM with the Intel Atom Z3560 processor layered underneath as PoP.
Realtek ALC 5647 audio chip.
Broadcom BCM4339XKUBG - Dual band WiFi controller.
The proximity sensor, notification LEDs and the 3.5 mm audio jack are all soldered to the motherboard.
The front and rear cameras can be easily removed from the motherboard
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-20 03:29:02 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 6 of 6
Related Documents 171j1w
Asus Zenfone 2 Teardown 1k5xo
November 2019 40
Asus Zenfone 2 Manual 2c6h5s
December 2019 54
Asus Zenfone 5 Manual 4e1gp
April 2023 0
Asus Zenfone Go - Manual 2u1e4
July 2022 0
October 2021 0
Asus Zenfone 5 Pl Manual 2kk4a
November 2019 50More Documents from "Fábio Domingues" 285w33
2c82t
November 2019 72
Catalogo Vertex Oil Spill Supply 2019 o6p19
August 2022 0
Biografria Levanta E Resplandece Blog Mr 475j6o
March 2021 0
October 2022 0
2c82t
October 2022 0