Xerox Workcentre 5225 - Nvram.pdf 4g4234

You can enter what is called “debug” mode and reset the if you have lost the to the printer (WARNING: Do not try adjusting anything in debug mode that you do not know how to do as it could have negative effects). In order to enter debug mode you will need to hold down the 0 button on the control for approximately 5 seconds, then while still holding this down press the start button. You will then be prompted to enter a code. The default is “6789”. Now that you are in debug mode you can change the name/ just like you would if you had already logged in as the as follows:

1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17.

Press the <Machine Status> button on the Control . Press the [Tools] tab. On the Tools screen press the [Authentication/Security] Settings. Press [System Settings]. Press [System ’s ID] On the System ’s ID screen, Select [Keyboard] Type in <name here> for the ID, and select [Save] On the Retype line, select [Keyboard] Enter the same ID, and select [Save] twice. If prompted [Do you want to change the System ’s ID?] select [Yes] Press [System ’s code]. On the code screen, Select [Keyboard]. Type in <code here> for the [New code], and select [Save]. In [Retype code], select [Keyboard]. Enter the same code, and select [Save] twice. In the [Do you want to change the System ’s code?] screen, select [Yes]. If prompted choose to reboot the machine after the changes have been made.